 |
KEYENCE IM-6120Dimensional measurement
|
|
Specifications Dimensional measurementSet up to 99 measurement points in as little as 5 seconds Dimensional measurement Dimensional measurementMinimum display unit : 0.1μm（1/10000mm） Dimensional measurementMeasurement dimensions : φ100×200mm |
 |
  |
KEYENCE VR-3050Measurement of sample surface roughness Measurement of unevenness step Measurement of coating layer Specifications Inspect 3D shapes in as little as 4 seconds Resolution : 0.5μm（5/10000mm） Measurement dimensions : 24×18×10Hmm> |
  |
SHIMAZU IRAffinity-1SPeak measurement of sample Qualitative analysis of oils, polymers, and fillers Foreign material analysis Specifications Wave number range : 7,800～350cm-1 Measuring method : Reflection and transmission Registered spectral data : about 12000 |
  |
KEYENCE VHX-5000Observation of sample surface
Observe details that cannot be confirmed visually Specifications Magnification : 0.1 - 200 times Observation method : Frontal and tilt observation  |
 |
Japan Avionics G100Testing of products with warm and cold sensation effects Temperature measurement of equipment and specified points in the factory Specifications Temperature range : -40 to 500°C Gradation : 256, 16, 8 Temperature searching : Maximum and minimum temperature search |
 |
SHIMADZU AGS-100NXTensile test Compression test Tensile test Abrasion test Peel test (90°, 180°) Adhesive strength test Assault test Specifications Force : Max. 1000N Stroke : Max. 1100mm   |
  |
Yuasa System |
 |
YASUDA No.183Confirmation of shock absorption of gel products
|
 Waveform at direct fall Max. 443.7Hz, 2sec. to stop |
 Waveform of falling ball on Crystal Gel sheet Max. 35.3Hz, 0.6sec. to stop |
 |
TEC GIHAN MSES-0512Measuring Young's modulus (storage modulus) Comparison of elasticity between real human body and sample Specifications Push-in force sensor load rating : 200±5N Tip ball indenter : φ10mm Push-in speed : 1.0，2.0，3.0，5.0，10.0mm/s  |
 |
Hitachi High-Tech Science |
Specifications
Frequency : 0.01 - 200Hz Temperature range : -150 to 600℃ Measuring range : 103 to 1013.5Pa Deform mode : Tension, bending, shearing, film shearing, compression, 3-point bending |
SpecificationsMaximum load : 50N Resolution : 0.01N Sampling speed : Max. 2000 times/sec. |
IMADA ZTS-50NMeasurement of tackiness of high-tackiness products 
|
TVB-25H ViscometerMeasuring the viscosity of materials Viscosity transition measurement by time curing of materials Specifications Measuring range : 100 to 320,000,000mPa･s Temperature control : Room temperature +10 to 200℃ |
TOKI TVB-25  |
 Print size : 210×297×200Hmm Material : Light-curing resin (acrylic) Data : STL |
KEYENCE AGILISTA-3100Sample shape check
 |
 |
ESPEC PR-2JKDurability test and life test by low temperature resistance, high temperature resistance, and humidity resistance Temperature and humidity cycle test to check the resistance to temperature and humidity changes Specifications Temperature range : -20 to 150℃ Humidity range : 20 to 98% Capacity : 225L |
 Size : 600×1800mm Static and dynamic pressure distribution measuring |
XSENSOR X3Development and testing of medical and nursing care products Checking the pressure dispersion of gel products  |
